Loading...
Complete fastener torque values for all engine components. Use a calibrated torque wrench for all installations.
Reference only; the manufacturer's current manual is authoritative when in doubt.
Use a wrench that covers the range needed (e.g. 5–80 ft-lb for most small engines). For break-in procedure, maintenance intervals, and tightening sequences, see the full manual on the engine page.
Scroll horizontally to see all columns
| Component | Torque (ft-lb) | Torque (in-lb) | Installation Notes |
|---|---|---|---|
| Cylinder Head Bolts | 18-22 ft-lb | 216-264 in-lb | Tighten in sequence, both cylinders |
| Connecting Rod Bolts | 14-16 ft-lb | 168-192 in-lb | Critical - do not over-tighten |
| Flywheel Nut | 70-75 ft-lb | 840-900 in-lb | Use thread locker |
| Spark Plug | 14-16 ft-lb | 168-192 in-lb | Hand tight + 1/4 turn (both) |
| Oil Drain Plug | 14-16 ft-lb | 168-192 in-lb | Replace crush washer |
| Carburetor Mounting Bolts | 8-10 ft-lb | 96-120 in-lb | Even pressure |
| Exhaust Mounting Bolts | 14-16 ft-lb | 168-192 in-lb | Check after first run |
| Air Filter Cover Screws | 5-7 ft-lb | 60-84 in-lb | Snug only |
| Valve Cover Bolts | 8-10 ft-lb | 96-120 in-lb | Even pattern |
| Crankcase Bolts | 12-14 ft-lb | 144-168 in-lb | V-twin specific |
Complete fastener torque values for all engine components. Use a calibrated torque wrench for all installations.
Reference only; the manufacturer's current manual is authoritative when in doubt.
Use a wrench that covers the range needed (e.g. 5–80 ft-lb for most small engines). For break-in procedure, maintenance intervals, and tightening sequences, see the full manual on the engine page.
Scroll horizontally to see all columns
| Component | Torque (ft-lb) | Torque (in-lb) | Installation Notes |
|---|---|---|---|
| Cylinder Head Bolts | 18-22 ft-lb | 216-264 in-lb | Tighten in sequence, both cylinders |
| Connecting Rod Bolts | 14-16 ft-lb | 168-192 in-lb | Critical - do not over-tighten |
| Flywheel Nut | 70-75 ft-lb | 840-900 in-lb | Use thread locker |
| Spark Plug | 14-16 ft-lb | 168-192 in-lb | Hand tight + 1/4 turn (both) |
| Oil Drain Plug | 14-16 ft-lb | 168-192 in-lb | Replace crush washer |
| Carburetor Mounting Bolts | 8-10 ft-lb | 96-120 in-lb | Even pressure |
| Exhaust Mounting Bolts | 14-16 ft-lb | 168-192 in-lb | Check after first run |
| Air Filter Cover Screws | 5-7 ft-lb | 60-84 in-lb | Snug only |
| Valve Cover Bolts | 8-10 ft-lb | 96-120 in-lb | Even pattern |
| Crankcase Bolts | 12-14 ft-lb | 144-168 in-lb | V-twin specific |